Factory Outlets Emery Sanding Belt - Types of sanding belt suitable for stone polishing and grinding – Fuke

Brown fused alumina Series Products

Brown fused alumina is an artificial corundum produced by melting and reducing three raw materials: bauxite, carbon material and iron filings in an electric arc furnace. The main chemical component is AL2O3, the content of which is 95.00%-97.00%, and a small amount of Fe, Si, Ti, etc.

Silicon Carbide Series Products

Silicon carbide is an inorganic substance with a chemical formula of SiC. It is made by high temperature smelting of raw materials such as quartz sand, petroleum coke (or coal coke), and wood chips (salt is needed to produce green silicon carbide) through a resistance furnace. There are two basic varieties of silicon carbide, black silicon carbide and green silicon carbide, both of which belong to α-SiC.

The characteristics of different stones

1. Marble is made on the basis of limestone. Its surface has good decorative properties after being ground and polished. However, its material is very soft and easily affected by external interference.
2. The surface layer of granite is hard and belongs to volcanic rock, and it has excellent wear resistance and corrosion resistance. It is usually used on kitchen countertops or on the ground.
3. Inorganic artificial stone has no carbon atoms inside, so its hardness is better than that of organic artificial stone.
4. The density of organic artificial stone is high, it will not absorb water easily, and it has good sealing performance, and the exfoliation rate is better than that of inorganic artificial stone. However, the texture is similar to plastic and will be affected by thermal expansion and contraction.

The base material of the abrasive belt must have a certain strength and a small elongation.
The strength of the base material is closely related to the strength of the abrasive belt. Only with high strength, the abrasive belt can withstand the impact of tensile load, alternating load, grinding load and expansion load during the grinding process.
Elongation is also a very important indicator of the base material. If the abrasive belt extends greatly under the action of external force, the abrasive particles will fall off and lose the grinding ability. Excessive extension will exceed the adjustable range of the abrasive belt tension of the grinder. As a result, the abrasive belt cannot be used.

Polishing Method

1. Contact wheel type
The abrasive belt grinds by contacting the workpiece with the contact wheel. It can be used to process the outer circle, inner hole and plane of the workpiece, and the contact wheel can be made into a certain shape to form the curved surface of the workpiece. Grinding with floating contact wheels can also be used for accompanying processing of irregular profiles.
2. Grinding plate type
During grinding, the abrasive belt contacts the workpiece through the pressure grinding plate. The pressure-grinding plate has a pressing effect and is generally used for plane processing, which can increase the contact area, improve the grinding efficiency and the geometric accuracy of the workpiece, especially the flatness.
3. Freestyle
The workpiece is in direct contact with the flexible abrasive belt without any object supporting the abrasive belt. It uses its own flexibility after the belt is tensioned to grind or polish the workpiece. This method is easy to adapt to the contour of the workpiece within a certain range, especially the irregular shape of the workpiece, and is mostly used in the processing of outer molding surface and chamfering, deburring, polishing and other processes.